Voltage Regulation

+3.3V Regulation/Ripple and Noise
Load Voltage
5% +0.61% (2mV)
10% +0.61% (2mV)
20% +0.30% (3mV)
50% +-0.00% (7mV)
80% -0.30% (9mV)
100% -0.30%(12mV)
110% -0.30% (13mV)
Crossload +12V max. +0.00 %
Crossload +3.3V/+5V max. -0.61 %

 

+5V Regulation/Ripple and Noise
Load Voltage
5% +0.60% (4mV)
10% +0.60% (5mV)
20% +0.40% (6mV)
50% +-0.00% (6mV)
80% -0.40 % (7mV)
100% -0.60 % (8mV)
110% -0.60 % (9mV)
Crossload +12V max. +1.20 %
Crossload +3.3V/+5V max. -0.20 %

 

+12V Regulation (Worst Ouput)/Ripple and Noise (Worst Output)
Load Voltage
5% +1.08% (17mV)
10% +0.92% (19mV)
20% +0.75% (23mV)
50% +0.58% (28mV)
80% +0.25% (36mV)
100% +0.08% (45mV)
110% -0.08% (47mV)
Crossload +12V max. +0.50%
Crossload +3.3V/+5V max. -0.42%

Noise Levels

Loudness (subjective)
Load Opinion
5% audible fan bearing
10% audible fan bearing
20% audible fan bearing
50% rotation noise and audible fan bearing
80% rotation noise and audible fan bearing
100% strong noise and audible fan bearing
110% strong noise and audible fan bearing

Efficiency and PFC

Efficiency and Power Factor 230 VAC
Load Efficiency PFC
5% 72.56% 0.799
10% 81.13% 0.812
20% 86.40% 0.943
50% 87.33% 0.959
80% 87.14% 0.972
100% 86.99% 0.985
110% 86.44% 0.987

 

Efficiency and Power Factor 115 VAC
Load Efficiency PFC
5% 69.44% 0.824
10% 79.49% 0.925
20% 84.30% 0.959
50% 86.76% 0.971
80% 86.23% 0.980
100% 85.95% 0.988
110% 85.66% 0.990
 

All the rails fall clearly within ATX specifications. They start slightly over the target voltage and end with results close to 0%. +3.3V and +5V show the best regulation, and will have no trouble with higher voltages. -0.60% at overload is one of the best results we have seen so far. 0.824-0.990 PFC is very good and most users will find 86-87% efficiency more than sufficient. While it doesn't quite make 80% efficiency at 10% load (115V), it is a good 80 Plus Bronze PSU for sure. Both smaller rails have less than 20mV ripple and noise, making this PSU a good choice.

Corsair TX550M Internal Design and Fan OCZ ZT550W Overview
Comments Locked

41 Comments

View All Comments

  • Rookierookie - Monday, March 26, 2012 - link

    >I think the days of the 550 watt psu are over unless you only do single card gaming and don't use the highest end cards.

    That's like saying that the days of the graphics card is over unless you play games and turn on graphic features.

    Other people do exist, you know.
  • retrospooty - Monday, March 26, 2012 - link

    " I think the days of the 550 watt psu are over unless you only do single card gaming and don't use the highest end cards."

    Off all gamers, PC gamers are the minority.
    Of PC gamers, high end cards are the minority
    Of high end cards, dual chip/SLI is the minority

    You are talking about the minority, of a minority within a minority.

    Of course this is a tech site and more of us here are likely to game on PC and have extreme setups and overclock to the highest possibility, but we are just a tiny fraction of the market.
  • bji - Monday, March 26, 2012 - link

    Not to dispute your point, but this is a PC component site so non-PC gamers are not reading these articles. Therefore your first categorization is irrelevant.

    It is true though that high end cards are in the minority in PC gaming, and SLI a minority within the high end card market. So the fraction we're talking about is still small, just not as small within the audience of Anandtech articles as you described.

    To try to stay on point: one of these power supplies comes with a feature that would prevent me from buying it, no matter what: the OCZ badge on the case.
  • gamoniac - Monday, March 26, 2012 - link

    My OCZ Fatal1ty 550W's 4+4 pin was only 45cm, posing an issue reaching the farthest 12v ATX connector if I route it behind the motherboard (I had to get an extension). It looks like OCS has listened and increased the length to 60cm. Well done.

    Corsair TX seems like a good choice, but I am not sure why they need to include two FDD connectors to clutter up the case, especially if it is not a modular PSU to begin with. Does anyone still have an FDD on their PC, let alone two? I got rid of my FDD a few years ago after collecting dust in my garage for a few years.
  • HowQuaint - Monday, March 26, 2012 - link

    Could you be more specific about the "magnetic amplifier" you specify in the OCZ unit? Wikipedia has an article about it but it doesn't seem to be a power supply technology. Since mag amps use a transformer-like device I'd guess it's a forward or flyback converter, which is more commonly used for the primary, high-voltage stage but it still works for low voltages. But saying that it "has no DC-DC converters inside" is inaccurate because any sort of secondary step-down qualifies as a DC-DC converter regardless of topology, and with cross-load numbers that low it definitely uses a secondary converter.
  • Martin Kaffei - Monday, March 26, 2012 - link

    Wikipedia is probably not the best source for information like this. As you might see there are two chokes with a black core between the 5VSB and main transformer. Those are the chokes for regulation directly behind the windings. During saturation the voltage comes through. During the (let's call it) "high impedance mode" a part of the voltage pulse gets cut.

    I didn't say there are no DC-to-DC converter. I know it is the most famous an easiest converter type. But in this case I'm talking about step down converter for 3.3V and 5V, who get current from 12V. Each output voltage has it's own regulation. Most common PSUs regulate 5V and 12V with the same IC which is bad for crossload regulation.

    Hope this was understandable since English is just my second language.
  • Leyawiin - Monday, March 26, 2012 - link

    The SeaSonic M12II 620 Bronze 620W is the exact same price as those two at Newegg and is a more robust and reliable power supply. I wouldn't touch one made by Great Wall or CWT when a superior SeaSonic built unit is available at that price, especially with a higher capacity.
  • dubyadubya - Monday, March 26, 2012 - link

    +1 good catch I agree 100%. That Seasonic is a way better deal, Better quality, more power for the same price its a no brainer. I'd own a CWT PSU but its a step down from a Seasonic brand or built by Seasonic PSU for sure. Personally never seen a Great wall built PSU as far as I know.
  • johan851 - Monday, March 26, 2012 - link

    Definitely. Pointing that out made me drop consideration for these - Seasonic makes a much better supply.
  • TegiriNenashi - Monday, March 26, 2012 - link

    Objective noise measurement is easy: there is free sound meter programs both for iPad and android.

Log in

Don't have an account? Sign up now