Today Intel is announcing its first SSD based on its own custom 6Gbps SATA controller. This new controller completely abandons the architecture of the old X25-M/320/710 SSDs and adopts an all new design with one major goal: delivering consistent IO latency. 

All SSDs tend to fluctuate in performance as they alternate between writing to clean blocks and triggering defrag/garbage collection routines with each write. Under sequential workloads the penalty isn't all that significant, however under heavy random IO it can be a real problem. The occasional high latency blip can be annoying on a client machine (OS X doesn't respond particularly well to random high IO latency), but it's typically nothing more than a rare hiccup. Users who operate their drives closer to full capacity will find these hiccups to be more frequent. In a many-drive RAID array however, blips of high latency from each drive can destructively work together to reduce the overall performance of the array. In very large RAID arrays (think dozens of drives) this can be an even bigger problem. 

In the past, we've recommended simply increasing the amount of spare area on your drive to combat these issues - a sort of bandaid that would allow the SSD controller to better do its job. With its latest controller, Intel tried to solve the root cause of the problem.

The launch vehicle for Intel's first 6Gbps SATA controller is unsurprisingly a high-end enterprise drive. Since the 2008 introduction of the X25-M, Intel has shifted towards prioritizing the enterprise market. All divisions of Intel have to be profitable and with high margins. The NAND Solutions Group (NSG) is no exception to the rule. With consumer SSDs in a race to the bottom in terms of pricing, Intel's NSG was forced to focus on an area that wouldn't cause mother Intel to pull the plug on its little experiment. The enterprise SSD market is willing to pay a premium for quality, and thus it became Intel's primary focus.

The first drive to use the new controller also carries a new naming system: the Intel SSD DC S3700. The DC stands for data center, which bluntly states the target market for this drive. While it's quite likely that we'll see a version appear in a high-end drive that could be used in a desktop, I don't know that we'll see a mobile version anytime soon for reasons I'll get to later.

The Drive

The S3700 comes in four capacities (100, 200, 400 and 800GB) and two form factors (2.5" and 1.8"). The 1.8" version is only available at 200GB and 400GB capacities. Intel sees market potential for a 1.8" enterprise SSD thanks to the increasing popularity of blade and micro servers. The new controller supports 8 NAND channels, down from 10 in the previous design as Intel had difficulty hitting customer requested capacity points at the highest performance while populating all 10 channels.

The S3700 is a replacement to the Intel SSD 710, and thus uses Intel's 25nm MLC-HET (High Endurance Technology) NAND. The S3700 is rated for full 10 drive writes per day (4KB random writes) for 5 years.

Intel SSD DC S3700 Endurance (4KB Random Writes, 100% LBA)
  100GB 200GB 400GB 800GB
Rated Endurance 10DW x 5 years 10DW x 5 years 10DW x 5 years 10DW x 5 years
Endurance in PB 1.825 PB 3.65 PB 7.3 PB 14.6 PB

That's the worst case endurance on the drive, if your workload isn't purely random you can expect even more writes out of the S3700. Compared to the SSD 710, the S3700 sees an increase in endurance even without allocating as much NAND as spare area (~32% vs. 60% on the 710). The increase in endurance even while decreasing spare area comes courtesy of the more mature 25nm MLC-HET process. It's process maturity that's also responsible for Intel not using 20nm NAND on the S3700. We'll eventually see 20nm MLC-HET NAND, but just not now.

Pricing is also much more reasonable than the Intel SSD 710. While the 710 debuted at around $6.30/GB, the Intel SSD DC S3700 is priced at $2.35/GB. It's still more expensive than a consumer drive, but the S3700 launches at the most affordable cost per GB of any Intel enterprise SSD. A non-HET version would likely be well into affordable territory for high-end desktop users.

Intel SSD DC S3700 Pricing (MSRP)
  100GB 200GB 400GB 800GB
Price $235 $470 $940 $1880

The third generation Intel controller supports 6Gbps SATA and full AES-256 encryption. The controller is paired with up to 1GB of ECC DRAM (more on this later). Intel does error correction on all memories (NAND, SRAM and DRAM) in the S3700.

Like previous enterprise drives, the S3700 features on-board capacitors to commit any data in flight on the drive to NAND in the event of a power failure. The S3700 supports operation on either 12V, 5V or both power rails - a first for Intel. Power consumption is rated at up to 6W under active load (peak power consumption can hit 8.2W), which is quite high and will keep the S3700 from being a good fit for a notebook.

Performance & IO Consistency

Performance is much greater than any previous generation Intel enterprise SATA SSD:

Enterprise SSD Comparison
  Intel SSD DC S3700 Intel SSD 710 Intel X25-E Intel SSD 320
Capacities 100 / 200 / 400 / 800GB 100 / 200 / 300GB 32 / 64GB 80 / 120 / 160 / 300 / 600GB
NAND 25nm HET MLC 25nm HET MLC 50nm SLC 25nm MLC
Max Sequential Performance (Reads/Writes) 500 / 460 MBps 270 / 210 MBps 250 / 170 MBps 270 / 220 MBps
Max Random Performance (Reads/Writes) 76K / 36K 38.5K / 2.7K IOPS 35K / 3.3K IOPS 39.5K / 600 IOPS
Endurance (Max Data Written) 1.83 - 14.6PB 500TB - 1.5PB 1 - 2PB 5 - 60TB
Encryption AES-256 AES-128 - AES-128
Power Safe Write Cache Y Y N Y

Intel is also promising performance consistency with its S3700. At steady state Intel claims the S3700 won't vary its IOPS by more than 10 - 15% for the life of the drive. Most capacities won't see more than a 10% variance in IO latency (or performance) at steady state. Intel has never offered this sort of a guarantee before because its drives would vary quite a bit in terms of IO latency. The chart below shows individual IO latency at steady state (displayed in IOPS to make the graph a bit easier to read) for Intel's SSD 710:


Note the insane distribution of IOs. This isn't just an Intel SSD issue, click the buttons above to look at how Samsung's SSD 840 Pro and the SandForce based 330 do. All of these drives show anywhere from a 2x - 10x gap between worst and best case random write performance over time. Lighter workloads won't look as bad, and having more spare area will help keep performance high, but Intel claims the S3700 is able to tighten its IO latency down to a narrow band of about 10 - 15% variance.

Intel also claims to be able to service 99.9% of all 4KB random IOs (QD1) in less than 500µs:

To understand how the S3700 achieves this controlled IO latency, we need to know a bit more about Intel's older controllers. In researching for this article, I managed to learn more about Intel's first SSD controller than I ever knew before.

A Brand New Architecture & The Old Indirection Table
Comments Locked

43 Comments

View All Comments

  • nathanddrews - Tuesday, November 6, 2012 - link

    C'mon, man! You're killing me! XD
  • Pandaschnitzel - Thursday, November 8, 2012 - link

    If the encryption is based on SED I would like to see another comparison. Windows 8 and the Bitlocker allow drive encryption like Truecrypt. The difference is that the Bitlocker can use the TPM of the motherboard. With an SSD based on the SED standard the TPM could directly use the hardware encryption of the SSD bypassing the CPU. This should result in significant performance gains compared to standard encryption. Here the penalty of encryption would be interesting. The new Bitlocker also allows to only encrypt the used sectors. This is very important for SSDs because previously the whole drive was encrpted which had negative impact on SSDs - at least without massive overprovisioning.
  • jamescox - Friday, March 1, 2013 - link


    I don't care about battery life too much. I mostly have my laptop plugged in. I don't think I would have issues with write endurance of a lower priced drive, but I would pay significantly more for higher reliability (no crashes, hangs, or data corruption). I think the consistent response time would be a big plus, especially if the drive was being used for swap space.

    Would something like the 100 GB version take too much power? It looks like the max power consumption is only around 3 W for the 100GB version, compared to 0.6 to 0.9 for more other consumer drives. It seems to be selling for more than MSRP ($235) right now though. About $270 is the lowest I have seen for 100 GB version.

Log in

Don't have an account? Sign up now